1. Hold down theSET button while firmly pressing in the TIMER button. (The TIMER button has a child tamper and water resistant cover. You may need to press with your fingernail to feel the click of the mechanical button under it.)
2. Release both buttons when “PLAY” appears. (“PLAY” will flash for 5 seconds.)
3. While flashing, press only the TIMER button again to select the mode: PLAY | 30 | 60 | 90 | OFF
That's it!When the flashing stops, your mode is set. To change modes, repeat steps 1 through 3.
In PLAY mode you can play the song and lights simply by pushing the TIMER button.
In the 30, 60 and 90 minute count down modes, the song and lights play ONLY at the end of the timer cycle.
Off mode stops the timer.
PLAY – TIMER button activates song and lights. (Manually play without waiting for a timer.)
30:00 – 30 minute timer cycle (Music and lights play at the end of each timer cycle.)
Use a paper clip to depress the spring bars and remove the watch band from the watch case.
Use the small jeweler’s (Phillips head) screwdriver to remove the three screws on the back of the watch case. Remove the back half of the watch case to see the circuit board.
Remove the circuit board from the watch case to see the attached batteries. Replace the batteries with the two alkaline button cell batteries provided, making sure the positive (flat) side of both batteries face up as shown.
Reverse steps 1-3. Place the circuit board with new batteries back inside the watch case. Secure the watch case using the original screws and replace the watch band.
Potty Watch is for everyone. You can review reviews on Facebook, Amazon or search #pottywatch on Instagram to see the thousands of people who have posted their stories of how the Potty Watch has helped them.